Information and Instructions

Redwood and Cedar Wind Ornaments

Sunrise Arts redwood and cedar wind ornaments are coated with Thompsons WaterSeal wood preserver. The natural wood beauty of the wood will last for years, but you can keep it looking new even longer by periodically recoating it with a wood preserver. Please see the directions that come with your wood preserver product for specific instructions.

Hanger cord adjustment

A small bag of hanger cord parts was included in your package.  Use the parts as needed in the following steps.  

2. Push the cord up through the cone to expose the end of the cord.

3. Clip the cord to the desired length, leaving a little extra to tie a knot (about ½ inch).

4. Put a new crimp tube on the cord and slid it down several inches.

5. Tie a new knot at the end of the cord.  Leave about ¼ inch of cord past the knot.

6. Slide the crimp tube up to the knot.

7. Squeeze the crimp tube near the knot with a pair of needle nose pliers.  Don’t squeeze too hard.  Squeeze just enough so that the crimp tube will stay put on the cord. Don’t squeeze hard enough to crush the cord or it may weaken it and cause it to break.

8. Slide the cone over the crimp tube.  Gently tug on the cord to insure the crimp tube is seated in the cone. 

9. Replace the top ring. Twist it to re-close.